The Gate to Source voltage should be under ☒0V and do not operate and store the transistor in temperature below -55 Celsius and above +155 Celsius. To get long term and stable performance from BS170 MOSFET in your circuits do not drive load of more than 60V and 500mA. And the gate in MOSFETs requires small amount of voltage to control current through its Drain to Source. In MOSFETs the Gate is used to control the transistor where as in BJT it is Base, but the BJTs are current control devices and MOSFETs are voltage control devices. Wiring the MOSFETs are almost same as we wire BJT transistors. On the other hand it can also be used as an audio amplifier, in audio amplifier stages, low level signal amplification etc. Additionally it can also be used at the output of microcontrollers and platforms like arduino and raspberry pi to drive loads. Other than that it can also be used as an amplifier and you can use it in your audio amplifier circuits and also for any general purpose signal amplification requirements.īS170 can be used for any general purpose switching and amplification purposes, it can be used as a switch to drive loads under 500mA which is enough drain current to drive most of the relays, lamps, LEDs etc. It can also perform well on low voltage due to which it is an ideal MOSFET to use in portable and battery operated applications. It is able to perform fast switching and capable to switch load in around 7 nanoseconds due to which it can be used in high speed circuits. When used as switch it can drive load of 500mA. It can be used for both switching and amplification purposes.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |